大洋勘探船压载水系统设计

分析和研究最新生效的几种常用压载水管理公约规范,调研和对比目前市场上常用的几种压载水处理措施,综合对比分析各种压载水处理技术并结合大洋勘探船的特点选择合适的压载水处理技术,设计研究一型经济和环保的压载水系统,并进行压载水处理装置设备选型、系统设计和相关设备布置等。     

轨腰仿生自分层防腐梯度涂料合成及影响因素和结构探究

目的仿荷藕结构及功能,制备一种自分层防腐涂料。方法合成聚氨酯改性环氧树脂(PU/EP)及氟硅改性丙烯酸树脂(氟硅改性PAA),将两种树脂共混形成自分层涂料。通过铅笔硬度测试、机械性能测试、接触角测试、耐老化测试、划格法附着力测试、电化学阻抗测试等,分别评价两种树脂比例、混合溶剂比例对涂膜自分层行为及性能的影响,并通过SEM-EDS、红外光谱等表征技术分析涂膜分层后的结构。结果当PU/EP∶氟硅改性PAA=1∶1时,接触角达到96.0°,柔韧性为0.5 mm,耐冲击为50 cm,附着力等级为1,失光率降至19%;乙酸丁酯(NBAC)∶正丁醇(NBA)=4∶6时,涂膜分层情况良好,接触角达到107.7°,浸泡水中48 h耐水性无变化,失光率降至17%。SEM-EDS、红外光谱分析表明,自分层涂膜上层为氟硅改性PAA、底层为PU/EP,中间存在过渡涂层,过渡层两种树脂中的─COOH、─OH、环氧基发生反应,使整个涂层更具稳定性。经由EIS分析,在3.5%NaCl溶液中浸泡40天后,腐蚀介质没有渗透涂膜到达基底金属界面。结论制备的轨腰仿生自分层涂膜的机械性能、附着力、疏水性、耐老化、防腐蚀性能优异,涂膜结构稳定。     

齐大山铁矿南帮含水构造带探测研究

为解决采空区突发涌水给矿山安全生产带来的安全威胁,以齐大山铁矿为研究对象,以高密度电阻率法含水构造带理论模型的正演模拟研究为基础,运用高密度电阻率法对采场南帮含水构造带的异常范围进行了圈定;运用瞬变电磁法进行了二次探测,并对高密度电阻率法所圈定的异常范围进行了验证。研究表明:含水构造带显示为低阻异常特征,在高密度电阻率法探测成果图中显示的两处低阻异常与含水构造带理论模型的正演模拟结果一致;同时,在瞬变电磁法探测成果图中显示的低阻区域均在高密度电阻率法所圈定的低阻异常范围内,二者相互验证,这两处低阻异常均为含水构造带的地球物理异常特征的显示,表明采用高密度电阻率法和瞬变电磁法组合识别技术可实现对隐伏含水构造带的先导性探测。     

Transesterification of Palm-based Methyl Palmitate into Esteramine Catalyzed by Calcium Oxide Catalyst

The technology for transesterification reactions between methyl esters and alcohols is well established by using classical homogeneous alkaline catalysts, which provide high conversion of methyl esters to specialty or nonindigenous esters. However, in certain products where the purity of the esters is of concern, the removal of homogeneous catalysts after the completion of the reaction is a challenge in terms of production cost and water footprint. Therefore, a study to investigate the potential of heterogeneous catalysts was conducted on reactions between methyl palmitate and triethanolamine. The degree of basicity and active surface area of calcium oxide (CaO), zinc oxide (ZnO), and magnesium oxide (MgO) were first characterized by using temperature-programmed desorption (TPD-CO₂) and Brunauere–Emmett–Teller (BET), respectively. Among the metal oxides investigated, the CaO catalyst showed the best catalytic activity toward the transesterification process as it gave the highest conversion of methyl palmitate and yielded fatty esteramine compositions similar to the conventional homogeneous catalyst. The optimum transesterification condition by using the CaO catalyst utilized a lower vacuum system of approximately 200 mbar, which could minimize a considerable amount of energy consumption. Furthermore, low CaO dosage of 0.1% was able to give a conversion of 94.5% methyl ester and formed esteramine at 170 °C for 2 h. Therefore, the production of esterquats from esteramine may become more economically feasible through the methyl ester route by using the CaO catalyst, which can be recycled three times.     

Single-Crystalline TiO2(B) Nanobelts with Unusual Large Exposed {100} Facets and Enhanced Li-Storage Capacity

The {100} facet of single-crystalline TiO₂(B) is an ideal platform for inserting Li ions, but it is hard to be obtained due to its high surface energy. Here, the single-crystalline TiO₂(B) nanobelts from H₂Ti₃O₇ with nearly 70% {100} facets exposed are synthesized, which significantly enhances Li-storage capacity. The first-principle calculations demonstrate an ab in-plane 2D diffusion through the exposed {100} facets. As a consequence, the nanobelts can significantly accommodate Li ions in LiTiO₂ formula with specific capacity up to 335 mAh g⁻¹, which is in good agreement with the electrochemical characterizations. Coating with conductive and protective poly(3,4-ethylenedioxythiophene)-poly(styrenesulfonate), the cut-off discharge voltage is as low as 0.5 V, leading to a capacity of 160.7 mAh g⁻¹ after 1500 cycles with a retention rate of 66% at 1C. This work provides a practical strategy to increase the Li-ion capacity and cycle stability by tailoring the crystal orientation and nanostructures.     

喷雾干燥法制备材料论文的指导方案

喷雾干燥技术的突出特点是将液态物料瞬时干燥成固体粉末或者颗粒。我们课题组在指导本科生毕业论文中采用了喷雾干燥法制备碳包覆铌酸钛材料的实验,在实验过程中我们发现了一些问题,如喷雾干燥机需要适当预热、喷头容易堵赛和收集原料不干等问题。我们就以上问题进提出了相应的对策,这加深了本科生对喷雾干燥实验的体会和认识,培养了学生在独自实验时面对问题解决问题的能力。     

红枣多糖提取、分离纯化及生物活性研究进展

红枣作为我国传统的药食同源的天然保健果品,已有近四千多年的栽植和食用历史。红枣多糖是一种复合杂多糖,现代药理学研究表明多糖是红枣果中主要的功能活性成分之一,具有抗氧化、抗肿瘤、免疫保肝及调节肠道菌群等功能。本文系统地综述了国内外近年来关于红枣多糖提取、分离纯化、结构特征及生物活性的研究进展,以期为提高红枣多糖的利用以及为进一步深入研究红枣多糖构效关系提供理论依据。     

水文序列相依变异识别的RIC定阶准则——以自回归模型为例

水文过程相依性是水文变异的主要表现形式之一,应用自回归模型对其进行拟合时合理确定模型阶数是一个难点问题。本文在分析AIC和BIC准则的基础上,提出了一种以原序列与其相依成分的相关系数作为拟合度指标,同时借用信息熵形式的函数式,作为模型不确定性度量指标的自回归模型定阶准则(简称RIC准则)。以AR(1)、AR(2)、AR(3)和AR(4)模型为例进行统计试验,将不同序列长度下该准则的定阶准确率与其他定阶准则进行比较,试验结果表明,RIC准则对于上述模型均具有较好的适应性,且定阶准确率远高于AIC准则,其中对于前三阶模型RIC准则优于BIC准则,但四阶模型略低于BIC准则。RIC准则的优势是可以同时满足模型定阶、相依程度分级与模型检验的需求,将其应用于实测水文序列分析,结果显示,该准则能较准确地识别自回归模型的阶数,且符合提出的"相依有变异而残差无变异的最小阶数"的检验标准。     

马钢张庄矿高压辊磨机装配工艺研究

针对马钢张庄矿高压辊磨机辊套疲劳断裂严重、对辊精度不能满足生产要求等问题，马钢重机公司根据张庄矿实际生产要求对对辊进行国产化，国产化内容包括辊轴、辊套等零部件的新制以及装配工艺攻关，通过技术研发同时结合实际生产经验，成功对高压辊磨机辊套与辊轴以及辊轴与轴承进行装配，完成了张庄矿高压辊磨机整对对辊的国产化，为该型设备后续生产及优化提供了理论和实践参考依据。